kw_spi: fix clock prescaler computation

The computation was not correct with low clock values: setting a 1MHz
clock would result in an overlap that would then configure a 25Mhz
clock.

This patch implements a correct computation method according to the
kirkwood functionnal spec. table 600 (Serial Memory Interface
Configuration Register).

Signed-off-by: Valentin Longchamp <[email protected]>
cc: Holger Brunck <[email protected]>
cc: Prafulla Wadaskar <[email protected]>
Acked-by: Prafulla Wadaskar <[email protected]>
Signed-off-by: Prafulla Wadaskar <[email protected]>

diff --git a/arch/arm/include/asm/arch-kirkwood/spi.h b/arch/arm/include/asm/arch-kirkwood/spi.h
index c79bed7ed9de587767e0f0c4d1417a65a1040002..113f258756cc6962efbdf644ad314199e338b826 100644 (file)
--- a/arch/arm/include/asm/arch-kirkwood/spi.h
+++ b/arch/arm/include/asm/arch-kirkwood/spi.h
@@ -49,6 +49,7 @@ struct kwspi_registers {
 #define MISO_MPP11     (1 << 2)
 
 #define KWSPI_CLKPRESCL_MASK   0x1f
+#define KWSPI_CLKPRESCL_MIN    0x12
 #define KWSPI_CSN_ACT          1 /* Activates serial memory interface */
 #define KWSPI_SMEMRDY          (1 << 1) /* SerMem Data xfer ready */
 #define KWSPI_IRQUNMASK                1 /* unmask SPI interrupt */

diff --git a/drivers/spi/kirkwood_spi.c b/drivers/spi/kirkwood_spi.c
index f4523a39291decba35409cfb79ab2f513b978c43..a7cda751bd0a3eba5663331a7e16a724cd370b56 100644 (file)
--- a/drivers/spi/kirkwood_spi.c
+++ b/drivers/spi/kirkwood_spi.c
@@ -56,8 +56,9 @@ struct spi_slave *spi_setup_slave(unsigned int bus, unsigned int cs,
        writel(~KWSPI_CSN_ACT | KWSPI_SMEMRDY, &spireg->ctrl);
 
        /* calculate spi clock prescaller using max_hz */
-       data = ((CONFIG_SYS_TCLK / 2) / max_hz) & KWSPI_CLKPRESCL_MASK;
-       data |= 0x10;
+       data = ((CONFIG_SYS_TCLK / 2) / max_hz) + 0x10;
+       data = data < KWSPI_CLKPRESCL_MIN ? KWSPI_CLKPRESCL_MIN : data;
+       data = data > KWSPI_CLKPRESCL_MASK ? KWSPI_CLKPRESCL_MASK : data;
 
        /* program spi clock prescaller using max_hz */
        writel(KWSPI_ADRLEN_3BYTE | data, &spireg->cfg);